TEST'O

capturetesto

Declaration of conformity


 

User guide


  • Set the devEUI appEUI on the network on which you want to test the RF range.
  • Open the device and switch ON. Device rings until associating to the network.
  • 5 frames is sent after association with 15 seconds of delay.
  • After transmitting, there is 2 indicators: the first one is the quality of the Transmission, the second one is the quality of reception.
    • Transmission:
      • Red: The signal transmitted by the device is VERY BAD receipt by the gateways. Risk of loss a lot of uplink. Try to put the device higher or in other place.
      • Orange: The signal transmitted by the device is BAD receipt by the gateways.
      • Green: The signal transmitted by the device is GOOD receipt by the gateways.
      • GreenGreen: The signal transmitted by the device is VERY GOOD receipt by the gateways.
    • Reception:
      • Red: The signal received by the device is VERY BAD. Risk of loss a lot of downlink. Try to put the device higher or in other place.
      • OrangeThe signal received by the device is BAD.
      • GreenThe signal received by the device is GOOD.
      • GreenGreenThe signal received by the device is VERY GOOD.
  • Put a magnet quickly on the  "ILS" sticker to relaunch a burst of transmitting.

Battery


  • When the battery is over, you can replace it by 2 x 1.5V AAA battery.
  • It is possible to use 2 AAA rechargeable battery if necessary.

Bluetooh and Android Application


It is possible to use remotly the Test'o.

  • Install application on your Android mobile phone: unzip the apk
  • Run the Testo application:
  • Once the Test'o device switched ON, do a scan on the application:

screenshot_20201104-125310

  • The Test'o device appears on the application, click on it to work with:

screenshot_20201104-125325

  • After each reception the following window is refreshed:

 

captureappliandroid

  • Click on Graph to see all recorded datas:

captureappgraphselectionv085

  • RX graph: SNR, RSSI and SF of the Downlink

screenshot_20201203-144345

  • TX graph: Margin and SF of the Uplink

screenshot_20201203-144337

  • Click On Test Radio to launch a new burst of Uplink with the selected argument:

captureapptxradioselect

screenshot_20201104-125411

Print Friendly